For players that want to play with a loose dump pouch of darts and no magazines. Follower is sprung by a retractable keychain. Pulling the follower to the lower-most position will simultaneously pivot the door open. Follower retracts against the darts as soon as the door is closed. A magnet provides a soft detent for the door until the follower can advance after the first dart is fired.
File set includes motorplate, which makes soldering leads onto flywheel motors without grounding against the casing a lot easier.
Hardware Required
Standard screw lengths required for a normal Gryphon build M4 magnetic base hooks (for magnetic detent on magdoor) https://www.amazon.com/MHDMAG-Refrigerator-Accessories-Neodymium-Refrigerators/dp/B07N57H5F6/ 3/32" elastic (alternative option for trigger return) Retractable keychain or badge holder 3/4" long x 1/4" OD #4 nylon spacer 19CM length worker picatinny rail (if you can't print the rail from the original file set) with the holes drilled out to accept M3 screws Assembly oddities
To install or remove the follower into the dovetail in the right side of the magazine well you need to have the door removed from its hinges. This allows the hinges to rotate to facing downward so you can insert the follower, rotate the hinges 180 degrees to get the follower into the dovetail, then reattach the door in two halves so the fandle can slide in the open slot of the door assembly. Cutout in the right side of magtop allows the eyelet to be hooked onto the peg on the side of the follower once the follower is in the topmost position. After the eyelet is attached to the follower you put the nylon spacer into the cutout in the side of magtop, then fit the wireduct over it to retain it. Retractable keychain will need to be able to find inside of the "winder" print. Either resize the winder model so that the ones you have fit inside, or consider removing unneeded features of the winder using bolt cutters. Whatever clip, hook, or keyring that comes included on the end of the retractable keychain will need to be cut off and replaced by tying the eyelet print onto the end. You will want to loop the string around one of your fingers a few times before attempting this because without anything on the end of the stringer the retractor can end up sucking the string inside itself where you can't get it back.
- User
STICKER PACK