Rubber Band Joltlike

3D Printed Blaster By LinKai

這是一款以JSPB為理念 用水管作為主結構 但是以橡皮筋為主動力製成的手掌型泡棉彈發射器 橡皮筋三折初速可達15mps/50fps(依槍體氣密度而定) 模型列印方向請注意 填充度盡量至少40%較佳 ==Tools== PVC Glue(PVC水管膠) Super glue(強力膠/AB膠) PVC pipe cutter(水管剪) Screw driver(螺絲起子) Box cuter(美工刀) Lighter(打火機) Tweezers(鑷子) Petroleum Jelly(凡士林) ==Parts== Screws(螺絲) M3x6mm x4 M3x8mm x2 M3x16mm x2 Spring(彈簧) 4mmx14mm x1 O-ring(O環) P18 x1 (ID=17.8mm OD=22.6mm) PVC pipe(PVC水管) 3/8' Thick tube 75mm x1 3/4 Thin tube 50mm x1 etc(其他) RubberBand OD=50mm x1

Master Blaster List
Join the Conversation about foam flinging, share suggestions, keep tabs on updates.
DartSweep is not affiliated, associated, endorsed by, or in any way connected with Nerf, Dart Zone or any other brands referenced here. We just like flinging foam, be cool.
ClickTap To Open